This will enable the Scandisk command on your Computer. In the C: DOS>Type Scandisk and tap on entering.In MS-DOS, users must type, CDDOS and tap on entering.For the users of Windows 3.X, check File and then Exit in order to get to MS-DOS prompt.For the ones running MS-DOS 6.2 or 6.22, here are the steps to run Scandisk Scandisk was introduced with MS-DOS 6.2, and it has been here since then. So, to help our user segment, we list out the steps that can help them with the Scandisk Command. The computer is now required to be restarted in order to run the Scandisk command without getting interrupted.īefore you question our love for the primitive Windows variants, it is important to note that even today some very advanced users prefer MS-DOS when it comes to ensuring the success of their programs and applications.Click on the ‘Tools’ tab and click check now in order to scan the drive for errors.You are now required to click on Properties.Right-click the local drive you have highlighted in the above step.This can be done through a single click on it We recommend the following steps when you wish to run the Scandisk command in the above-listed variants of Windows: In the following section, we look at how to run the Scandisk command in different versions of Windows.įor Microsoft Windows XP, 2000, Vista, and 7 Users: Part 1: How to run the Scandisk Command in different versions of Windows

Part 3: Advantages of using the Scandisk Command.Part 2: What is the Scandisk Command in Windows Operating System.Part 1: How to run the Scandisk Command in different versions of Windows.

Disk scanner windows 10